Skip to main content

Period End

The Period End procedure closes the current period and moves the payroll into the next period, ready for processing.


When to Do a Period End​

Do a Period End after:

  • All transactions for the period have been processed
  • The Calculation Routine has been run
  • All reports have been printed and filed
  • A backup has been taken

Important: When a Period End is done in one module (Payroll, Time Control, or Belina Connect), it is done in all modules simultaneously. If you have more than one module registered, always do the Period End from the Payroll module.


Period End Steps​

  1. Go to Utilities → Period End
  2. The Period End screen shows the next period number
  3. Tick the checkbox: "I have taken a Backup and can proceed with Period End"
  4. Click OK

Caution: The Period End procedure cannot be interrupted once it has started. If it is interrupted (e.g. by a power failure), restore the backup taken before the Period End and start again. A UPS (Uninterrupted Power Supply) is strongly recommended.


After Period End​

Once the Period End is complete:

  • The payroll moves to the next period
  • You can begin processing transactions for the new period
  • Add any new employees, update employee details, and start entering transactions

Backup Before Period End​

Always take a backup immediately before doing a Period End:

  1. Go to File → Backup
  2. Click the ellipsis button (...) to select the backup destination
  3. Click Backup

Store backups on reliable media:

  • Cloud storage (Google Drive, OneDrive) — recommended
  • Flash drive stored off-site

Keep a separate backup for each period — do not overwrite previous backups.

Was this page helpful?