Skip to main content

Getting Started — Belina Time Control

Belina Time Control is a biometric time and attendance system that integrates with Belina Payroll HR. This guide walks you through setting up the system from scratch.


Overview​

StepWhat You Do
1Check system requirements
2Connect and configure the clock
3Set up slots, shifts, and rotations
4Set up users and access control
5Sync employees to the clock
6Enrol fingerprints
7Allocate employees to rotations
8Download attendance and process

Step 1 — System Requirements​

Belina Time Control runs on the same machine as Belina Payroll HR. See System Requirements for hardware and software specifications.

The biometric terminals connect to the software via:

  • Ethernet cable (recommended)
  • Wireless (TFT500 and TFT600 models)
  • Serial cable (RS232/RS485 — older method)
  • USB flash drive (for sites without network connectivity)

Step 2 — Connect and Configure the Clock​

See Setting Up Clocks & Networking for the full clock configuration process.

In summary:

  1. Assign the clock an IP address within your network range
  2. Register the clock in Belina under Setup → Clocks
  3. Test the connection

Step 3 — Set Up Slots, Shifts, and Rotations​

Before allocating employees, define the working time patterns:

  • Slots — individual time blocks (e.g. Morning: 07:00–16:00)
  • Shifts — combinations of slots (e.g. Day Shift = Morning slot)
  • Rotations — weekly patterns of shifts (e.g. Mon–Fri Day Shift, Sat–Sun Rest)

Go to Setup → Slots, Shifts & Rotations

→ Full details: Slots, Shifts & Rotations


Step 4 — Set Up Users and Access Control​

Set up Time Control users and their access levels.

Go to Setup → Users

→ Full details: Users & Access Control


Step 5 — Sync Employees to the Clock​

After capturing employees in Belina, upload their names to the clock:

  1. Go to Setup → Clock Users
  2. Click Sync
  3. Select From Belina to Clock
  4. Tick the clock(s) to sync to
  5. Click OK

Step 6 — Enrol Fingerprints​

On the clock:

  1. Press the Menu button
  2. Go to User Mng → Manage
  3. Scroll to the employee and press OK
  4. Select Enrol FP and press OK
  5. Press the employee's finger three times on the scanner
  6. When "Enrolled Successfully" appears, capture additional fingers (recommend at least 3: thumb, index, and one other)
  7. Press Esc, scroll to OK, and save

After enrolling, sync fingerprints back to Belina:

  1. Go to Setup → Clock Users → Sync
  2. Select From Clock to Belina
  3. Tick the clock and click OK

→ Full details: Fingerprint Enrolment


Step 7 — Allocate Employees to Rotations​

Individual employee:

  1. Go to Edit → Employee Master
  2. Open the employee's record
  3. Click the T&A Settings tab
  4. Select the rotation from the Shift Rotation dropdown
  5. Click OK

Bulk allocation:

  1. Go to Edit → Bulk Employee Master Update
  2. Select the rotation from the Shift Rotation dropdown
  3. Tag the employees and click OK

Step 8 — Download Attendance and Process​

Each period, download the attendance log from the clock and run the Calculation Routine:

  1. Download attendance (via network or USB)
  2. Save the log to the database
  3. Go to Process → Calculation Routine

→ Full details: Downloading Attendance


Period End​

Important: Always do the Period End from the Payroll module, not from Time Control. The Period End applies to all modules simultaneously.

→ Full details: Period End

Was this page helpful?