Skip to main content

Setting Up Clocks & Networking

The Belina biometric terminal communicates with the Time Control software using an IP address over your network. Setting up a clock involves three stages: configuring the IP address on the clock, registering it in Belina, and testing the connection.


Supported Terminal Models​

ModelNotes
TFT400Standard wired terminal
TFT450Standard wired terminal
TFT500Supports wireless networking
TFT600Supports wireless networking

Connection Methods​

MethodDescription
Ethernet cableRecommended — reliable, fast, supports VPN for remote sites
WirelessAvailable on TFT500 and TFT600
Serial cableRS232/RS485 — older method, still supported
USB flash driveFor sites without network connectivity

Step 1 — Determine Your Network IP Range​

Before configuring the clock, find out the IP address range in use on your network. For example, if your network uses addresses from 192.168.0.10 to 192.168.0.50, you need to assign the clock an unused address in that range (e.g. 192.168.0.49).

To find your PC's IP address:

  1. Open Command Prompt
  2. Type ipconfig and press Enter
  3. Note the IPv4 Address — the clock must use an address in the same range

Step 2 — Set the IP Address on the Clock​

On the terminal:

  1. Go to the clock menu and select the Communication icon
  2. Choose Network
  3. Enter the desired IP address using the keypad
  4. Enter the Subnet Mask for the IP address

Step 3 — Register the Clock in Belina​

  1. Go to Setup → Clocks
  2. Click Insert
  3. The Clock Update window opens — enter:
FieldDescription
Clock DescriptionA name for this clock (e.g. "Main Entrance")
Clock IP AddressThe IP address you set on the clock
Max Clock ManagersNumber of administrators allowed on the clock
Display SettingsColour screen or standard
LanguageEnglish or Shona
Clock NumberSequential number for this clock
  1. Tick Have Attendance Records — this enables attendance tracking
  2. Tick Access Control only if this clock is used for door access control
  3. Click Connect — Belina establishes a connection with the clock
  4. When the connection is made, click Get Clock Status — the window populates with the clock's current settings
  5. Click OK — you will be prompted to restart the clock for settings to take effect

Step 4 — Test the Connection​

After restarting the clock, go back to Setup → Clocks, select the clock, and click Connect again. If the connection is successful, the clock status will display.


Wide Area Networking (Remote Sites)​

Terminals at remote locations can be connected over a VPN (Virtual Private Network). The network configuration is the same as a local area network — the VPN handles the distance.


Wireless Networking (TFT500 / TFT600)​

To configure a TFT500 or TFT600 for wireless:

  1. Connect the clock to your PC via Ethernet cable first
  2. Open the wireless configuration utility (available from Belina support)
  3. Click Test Connect to verify the wired connection
  4. Enter the wireless settings:
    • SSID — your wireless network name (ask your network administrator)
    • Wireless Model — typically Infrastructure
    • Authentication Type — typically WPA2PSK
    • Encryption Type — typically AES
    • WPA Password — your wireless network password
  5. Click ConfigMachine to set the wireless IP address, subnet mask, and default gateway
    • Use a static IP address — avoid DHCP as the IP changes on restart
  6. Click Set to apply the settings — the clock restarts automatically
  7. Remove the Ethernet cable after the clock restarts
  8. Register the clock in Belina using the wireless IP address

Server IP Address​

The server running Belina Time Control must have a static IP address. This ensures the clock can always find the server at the same address.

Contact your network administrator to assign a static IP to the server.

Was this page helpful?