Pay Increase Routines
Belina's Pay Increase routine applies salary increases to a group of employees at once — by a percentage, flat amount, or from an imported file. This avoids manually editing each employee's pay rate.
Before Running a Pay Increase
- Take a backup: File → Backup
- Ensure you are in the correct period (the period the increase takes effect)
- Have the approved increase amounts or percentages ready
Running a Bulk Pay Increase
Go to Data → Bulk Routines → Pay Increase

The Pay Increase screen opens:

Increase Options
| Method | Use When |
|---|---|
| Percentage | All selected employees get the same % increase (e.g. 10% across the board) |
| Flat Amount | All selected employees get the same fixed increase |
| By Grade | Different increase for each internal grade |
| From File | Import a spreadsheet with individual increase amounts per employee |
Steps
- Select the Increase Type (percentage or amount)
- Enter the increase value
- Select the Employee Range — by department, cost centre, grade, or all employees
- Select whether the increase applies to:
- Basic pay rate only
- Specific transaction codes (e.g. increase only the housing allowance)
- Click OK to preview
- Confirm to apply
Pay Increase by Grade
To apply different increases based on internal grade:
- Select By Grade as the increase type

- For each grade, enter the percentage or amount
- Click OK
Importing Increases from a Spreadsheet
For individual increase amounts per employee:
- Prepare a spreadsheet with columns: Employee Number, New Rate (or Increase Amount)
- Select From File as the increase type

- Browse to the spreadsheet and import
After the Increase
Verify the increases were applied correctly:
- Spot-check a few employees via Edit → Employee Master → Pay tab
- Run the Calculation Routine and check the Variance Report — the increase should show as a consistent difference from the prior period
Related Pages
Was this page helpful?